Garage Door Spring Repair in Garland, TX
A bang like a firecracker from the garage, then a door the opener can barely lift: that is usually a broken spring. Here's how to tell torsion springs from extension springs, what published prices look like, and how to get free quotes from independent garage door companies in Garland, Texas.
Get a Free Quote Call (877) 265-2390
Signs of a broken garage door spring
Springs counterbalance the door so the opener only guides it. When one breaks, the full weight lands on the opener or on you.
- A loud bang, often when no one was using the door
- A gap of an inch or two in the coil above the door
- The opener strains, lifts a few inches, then stops
- The door feels far heavier than usual by hand
- The door drops fast or slams on the way down
- One side sits lower, or a cable hangs slack
If you notice any of these, stop using the door and the opener. Running an opener against a broken spring can burn out its motor or pull the door out of its tracks, which turns one repair into two.
Garland Garage Door Experts is a free quote-matching service, not a garage door company. You describe the problem once, independent local garage door companies reply with quotes, and the company you choose does the work.
Torsion vs extension springs: which does your door have?
Stand inside the garage with the door closed and look up. Don't touch anything; you only need to see it.
| Torsion springs | Extension springs | |
|---|---|---|
| Where they sit | On a steel shaft across the top of the opening | Along each side, above the horizontal tracks |
| How they lift | Wound tight; they twist to raise the door | Stretched; they pull to raise the door |
| What a break looks like | A visible gap in the coil | A spring hanging loose, held only by its safety cable |
| Published replacement range | $200–$350 (Fixr, Jan 2025) | $120–$250 (Fixr, Jan 2025) |
Many newer two-car doors use torsion springs; older and lighter doors often use extension springs. That's a general pattern, not a rule.
Extension springs should have a safety cable running through each spring to contain a break. If yours don't, mention it on your request. The torsion vs extension springs guide covers the differences in more depth.
What a technician typically does on a spring call
Methods vary by company. A careful spring repair usually follows this order.
1. Check the whole system
The technician confirms which spring failed and looks at the cables, drums, bearings and rollers that took the shock.
2. Measure and match
Springs are matched to the door by wire size, length, inside diameter and door weight. A mismatch leaves the door unbalanced.
3. Price it in writing
You get an estimate that lists parts and labor, the trip fee, and the price for one spring versus two.
4. Replace and set tension
With proper winding bars and clamps, the new spring or pair is installed and tensioned for your door.
5. Balance and safety test
The door should stay put when stopped halfway. A good visit ends with an auto-reverse and photo-eye test.
Why springs wear out on Garland, TX doors
Garland's housing is older than most of DFW. The city's median home was built in 1978, compared with 1992 for Texas, and 54.8% of homes went up before 1980 (American Community Survey 2020–2024). In ZIP codes 75041 and 75042 in south and west Garland, the median build year is 1965 to 1968. Many of these doors are on their second or third set of springs, and some are on parts nobody has looked at in years.
Standard springs are commonly rated around 10,000 cycles. Fixr's figures put that at roughly 13 to 14 years at two cycles a day, 9 to 10 years at three, and 5 to 6 years at five. In neighborhoods where the garage opens onto a rear alley, the garage door often works as the household's front door, so it can rack up cycles faster than you'd guess.
DFW also averages about 106 days a year at 90°F or hotter and about 20 at 100°F or hotter (NOAA 1991–2020 normals, DFW Airport), so springs work a long season in a hot garage. DASMA, the door manufacturers' association, notes that rust weakens spring wire and that lubrication helps springs reach their rated life.
Most homes in Rowlett, Sachse and Wylie were built between 1990 and 2019, so many doors there are due a first or second spring. See how long garage door springs last for more on cycle life.
What garage door spring repair costs
No reliable Garland-specific price source exists, so these are dated national ranges. Use them to sanity-check written estimates, not as a price any company has offered.
| Item | Typical range | Source |
|---|---|---|
| Spring replacement | extension $120–$250; torsion $200–$350 | Fixr, Jan 2025 |
| Spring replacement (second guide) | $300–$540 | This Old House, Mar 2026 |
| Service call / trip fee | $50–$75 | Fixr, Jan 2025 |
| After-hours or emergency surcharge | +$100–$300 | Fixr, Jan 2025 |
Published national estimates, not quotes (Fixr, Jan 2025; This Old House, Mar 2026). Garland-area quotes vary.
What moves the number: torsion or extension, one spring or a pair, standard or higher-cycle springs, door size and weight (a 16×7 double door is heavier than an 8×7 single), cables or drums that also need replacing, and after-hours timing. The Garland garage door repair cost guide has a calculator, and the spring replacement cost breakdown goes line by line.
Safety first: no DIY on springs
Torsion springs store enough energy to cause serious injury. Leave spring and cable work to a trained technician. Winding a torsion spring takes purpose-made bars, and cables and bottom brackets stay under tension even when the door looks still.
While you wait for help:
- Leave a closed door closed, and unplug or don't use the opener
- Keep children and pets out of the garage
- Don't loosen, pry at or adjust anything on the spring shaft, cables or bottom brackets
- Pull the opener's emergency release only when the door is fully closed, because a raised door with a broken spring can drop
- If the door is stuck open, don't walk or drive under it
Broken spring with a car stuck inside: is it urgent?
It's urgent when the door is stuck open overnight, a car you need is trapped, or the door hangs crooked. A closed, secure door can usually wait for regular hours, which may save a surcharge and leaves time to compare written estimates.
Some local companies offer evening, weekend or emergency service, often at a higher rate (Fixr: +$100–$300). Mention urgency on your request and ask about after-hours fees before work starts. The emergency garage door repair page covers what to do in the meantime. You can also call (877) 265-2390 or use the form below.
Questions to ask before you approve a spring repair
- Is the estimate in writing, and does it include the trip or service-call fee?
- Torsion or extension, and are you replacing one spring or both? Why?
- What cycle rating are the new springs: standard or higher-cycle?
- Are cables, drums or rollers also being replaced, and are they listed separately?
- What are the warranty terms on parts and labor, in writing?
- Can I keep the old springs?
- Do you carry liability insurance, and do you have a local address?
Know your rights in Texas
Texas's Deceptive Trade Practices Act prohibits false statements about the need for parts or repairs, and claiming work was done when it wasn't (Bus. & Com. Code §17.46(b)(13), (22)). Ask for a written estimate and an itemized invoice that lists the parts replaced, and ask for your old parts back. This is general information, not legal advice.
Texas doesn't issue a state license for garage door companies, so ask for proof of liability insurance. If a technician on a spring call recommends a new opener or door, ask for a separate written quote. Be cautious with very low service-call ads, listings with no local address and large upfront cash deposits (BBB, 2026); see garage door repair scams in Texas.
Garage door spring repair FAQ
How much does garage door spring replacement cost in Garland, TX?
Fixr (Jan 2025) lists extension spring replacement at $120–$250 and torsion at $200–$350. This Old House (Mar 2026) shows $300–$540. These are published national estimates, not quotes. Spring type, one spring or two, door weight, worn cables and after-hours timing move the real price, so compare written estimates from Garland-area companies.
Can you open a garage door with a broken spring?
It isn't safe to count on it. With a broken spring the door's full weight sits on the opener or on whoever lifts it, and the door can drop fast. Leave a closed door closed and don't run the opener. If a car is stuck inside, say so when you request quotes or call, so companies can tell you how soon they can come.
Should both garage door springs be replaced at the same time?
On a two-spring door many technicians suggest replacing both, because springs installed together tend to wear at a similar rate and a matched pair keeps the door balanced. It's a common recommendation, not a rule. Ask the company to price one spring and two springs separately on the written estimate, and to explain why it suggests either.
How long do garage door springs last?
Standard springs are commonly rated around 10,000 cycles, one trip up and down. Fixr's figures work out to about 9 to 10 years at three cycles a day and 5 to 6 years at five a day. Households that use the garage as the main way in and out reach that number sooner. Higher-cycle springs cost more and last longer.
Get garage door spring quotes in Garland, TX
Say what happened, whether a car is stuck inside, single or double door, and the door's rough age. Independent local companies reply with no-obligation quotes.
Garage door stuck, loud or off track? Get free quotes.
Describe the problem once and independent garage door companies serving Garland, Texas can reply with no-obligation quotes.